Budget cost form:

Budget cost form:

	N°	Component/Activity	Description	Cost	Number of pieces
		Acid Ferric	This kind of acid is used to eliminate the excess of cooper in the Bakelite	$                39.00	X2
		Acrylic	This material is similar to crystal but is more resistance and lighter	$                99.00	X1 meter
		Arduino	This is a microcontroller platform, it’s like the brain of the project. We will use that to control all the dispositives.	$             300.00	X1
		Bakelite	This material is used to make the circuits of the project.	$                40.00	X1 30cm
		Water Bombs	The water bombs are used to collect the water and fill in the glass	$                  70	X5
		Cable	The cable is going to be to connect all the circuits with the bombs, servomotor and sensors.	$                  9.00	X1 5meter
		Display	The display is a little screen that shows numbers. We will going to show the number of full glasses.	$                55.00	X1
		Hose	This hose will going to be with the water booms to fill the glasses	$                15.00	X1 6meter
		RGB Sensor (tcs 3200)	The RGB sensor detects the different color of the glasses	$              175.00	X1
		Servomotor	The servomotor is a motor that you can control. This will move the base with the glasses	$              162.00	X1
		Screws	They will be in all of the structure of the project	$                  1.00	X40
		Relays	This dispositive is a switch to turn on and turn off the waterboms and the servomotor	$                  30.00	X5
			Total:	994$	1554

Integrator Project

Integrator Project:

Our integrator project is a prototype about an automatic water dispenser, this prototype is thought out to be in the restaurants to fill the water glasses with different kinds of liquids in a very low time. We are satisfied with our project because we think that is very functional for the and maybe tomorrow the restaurants will be more ‘automatic’ than now. This is the future of the world, use the technology to make our life’s easier. 

In our project we implement activities like program, cut, measure, design, investigate and others. First we design and investigate more about our project, how it can be more effective lighter and easy to use, then we start to build up the project cutting, measuring the physical parts. Then we start to program de Arduino that controls the dispositive of the project like the water bombs and the servomotor. Now we are in process to finish that.

Now we are trying to test all the dispositive of the project and doing little changes of the physical parts to improve the project. 

How to change a flat tire

1.- The first thing you need to do is park the car whith flashing lights and put on the parking break.

2-. The next part you need to do is Collect the tools to change the tire. The Jack, wheel tools and the new wheel.

3-. Put on the Jack under the frame of the wheel you want to change.

4-. Then you need to loosen the nuts with the with the cross key

5-.Lift the car using the Jack till the tire wheel stays full up

6-. Remove the nuts of the flat tire and then remove the flat tire

7.- Put the new tire and thighten the nuts a little bit in order, adjusting in pairs the opposite nuts.

8-. Lower the vehicle

9-. Using the cross key thighten the nuts with strenght

10-. Save all the tools

Diagram: